APRILIA eSR1 Mode D'emploi page 12

• Connect the display power cable to the main wiring
• Install the handlebar on the stem (do not crush the cables)
• Tighten the screws on the stem using the wrench supplied
• Adjust the stem closing mechanism*
MODEL REFERENCE PICTURE
eSR2
eSR2 EVO
eSR1
CAUTION
Assemble the item correctly. If, during assembly, any factory defects are detected, certain
steps are unclear or issues with assembly or adjustments occur, do not ride the vehicle and
contact your dealer or visit www.apriliasmartmovement.com for technical support.
Do not use accessories and/or additional parts that are not approved by the manufacturer.
Keep children away from plastic items (including packaging materials) and small parts that
may result in suffocation.
It is forbidden to modify or transform the item or any its parts in any way, as this may
impair efficiency, reduce structural integrity and cause damage. Remove any sharp
edges caused by misuse, breakage or damage to the item. If any factory defects, unusual
noises or faults are detected, do not ride the vehicle and contact your dealer or visit www.
apriliasmartmovement.com for technical support.
* ADJUSTMENT
There is a hex screw inside the mechanism.
If the handlebar stem is not very stable after
closing, adjust the screw in the mechanism, by
tightening or loosening it as required to increase
the stability of the stem.
Outside the mechanism there is a hex socket
screw. If the handlebar stem is not very stable after
closing, adjust the screw in the mechanism, by
tightening or loosening it as required to increase
the stability of the stem.
11