Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7.3 Adjusting the sensitivity
The sensitivity adjustment (in steps of 3 dB from
–18 dB to +12 dB) is used to match the micro-
phone input (2) to the signal level of the micro-
phone connected Adjust the sensitivity in such a
way that an ideal volume level of the microphone
is obtained When the volume is too high, the
microphone signal will distort; in this case, adjust
a lower value When the volume is too low, the
signal-noise ratio will be poor; in this case, adjust
a higher value
1) The display briefly indicates
the current sensitivity in dB Use the button
to adjust a higher value or the button
to adjust a lower value
2) To save the setting, press the button SET
7.4 Level attenuation
If the microphone level is too high even at the
lowest sensitivity, the level attenuation can be
activated additionally
1) The display indicates the current setting:
= attenuation deactivated
= attenuation activated
Use the button
or the button
to select the setting
2) To save the setting, press the button SET
7.5 Selecting the transmission power
There are two options for the transmission power:
high or low A high transmission power will in-
crease the range, but it will also reduce the bat-
tery life (the batteries will be discharged more
quickly)
1) The display indicates the current transmission
power:
= low transmission power
= high transmission power
Use the button
button
to select
2) To save the setting, press the button SET
All rights reserved by MONACOR
reproduced in any form or by any means for any commercial use
followed by
to select the setting
to select
or the
INTERNATIONAL GmbH & Co KG No part of this instruction manual may be
®
7.6 Key lock
Activating the key lock:
1) The display indicates
to select the setting
2) To save the setting, press the button SET
Deactivating the key lock:
1) Keep the button SET pressed for 3 seconds
until
of the indication
2) Use the button
3) To save the setting, press the button SET
8 Specifications
Carrier frequency range:
Audio frequency range:
Frequency stability:
Transmission power (EIRP)
Low:
High:
Power supply:
Max operating time:
Dimensions:
Weight:
Microphone input:
1 = ground
1
2 = 5 V operating voltage for the microphone
4
3 = signal input
2
3
4 = impedance correction
8.1 Lavalier microphone CM-501
(supplied with the transmitter)
Type /polar pattern:
Frequency range:
Impedance:
Sensitivity:
Max SPL:
Power supply:
Weight:
Subject to technical modification
Use the button
;
will be displayed
starts flashing
to select the setting
506 – 542 MHz
40 – 18 000 Hz
±0 005 %
10 mW
50 mW
2 × 1 5 V battery of
size AA
approx 25 h with
3400 mAh batteries
(alkaline)
65 × 100 × 22 mm
100 g
mini XLR, 4 poles
electret /cardioid
100 – 15 000 Hz
2 2 kΩ
3 2 mV/Pa at 1 kHz
130 dB
via pocket transmitter
20 g
11
Publicité
Table des Matières
