Stopping The Engine; Care & Maintenance - Power Fist 420cc OHV Mode D'emploi

V 4.4
6. Electric Start – Attach the battery (see Assembly & Installation -
Connecting the Battery). Turn the key to the start position and hold it there
until the engine starts. If engine fails to start within 5 seconds, release the
key and wait at least 10 seconds before operating the starter again.
7. If the engine floods, set the choke to the OPEN/RUN position, place the
throttle in FAST and attempt to start the engine again.
8. If the choke lever was moved to the CLOSED position to start the engine,
gradually move it to the OPEN position as the engine warms up.
The engine may make a metallic rapping noise (spark knock, ping) while running
under a heavy load. This is normal. Replace the fuel with premium quality gasoline
if the metallic rapping noise continues under normal load. Contact a qualified
mechanic if the pinging continues as this may indicate existing engine damage.

STOPPING THE ENGINE

CAUTION! Do not choke carburetor to stop engine.
IN AN EMERGENCY
Turn the engine switch (M) to the OFF position to stop the engine.
DURING NORMAL USE
Stop the engine by following this procedure:
1. Move the throttle lever (D) to the MIN. position.
2. Turn the engine switch (M) to the OFF position.
3. Turn the fuel valve (F) to the OFF position.
CARE & MAINTENANCE
WARNING! Always ensure that the engine is off before you begin any
maintenance or repairs. An active engine part can cause a severe injury,
amputation or death if a mishap occurs.
Visit www.princessauto.com for more information
420cc OHV Gas Engine with Electric Start 8449019
11