Before Starting The Engine - Power Fist 420cc OHV Mode D'emploi

V 4.4
The engine has an electric start option that requires a 12 volt battery (sold-
separately). Use a 12V battery with a rating of at least 18 ampere-hours with
the engine.
The engine has two battery cables with copper lugs. The polarity of each cable
is displayed on a rubber cover where they connect on either side of the starter
motor (Fig. 2-2).
1. Remove the wing nuts from the battery's
positive (+) and negative (-) terminals.
2. Slide the positive battery cable lug
(Fig. 2-3) onto the positive terminal. Coat
the cable end with grease and reattach the
wing nut. Tighten hand-tight.
3. Slide the negative battery cable lug
(Fig. 2-1) onto the negative terminal. Coat
the cable end with grease and reattach the
wing nut. Tighten hand-tight.
4. Secure the battery so it won't move
while the engine is in use.
OPERATION

BEFORE STARTING THE ENGINE

WARNING! Do not start or run engine in an enclosed area, even if the doors or
windows are open. Engine exhaust contains carbon monoxide (see Carbon
Monoxide Precautions).
1. Make sure spark plug (C), muffler (A), fuel cap (I) and air cleaner (B) are in
place and secured.
2. Ensure the spark plug lead is securely connected to the spark plug, otherwise
unintentional sparking can result, causing a fire or electric shock.
3. Check that all protective covers and guards are in place.
4. Check that all nuts, bolts and screws are tight.
Visit www.princessauto.com for more information
420cc OHV Gas Engine with Electric Start
2-1
2-2
2-3
8449019
Fig. 2
9