Engine Oil - Power Fist 420cc OHV Mode D'emploi

V 4.4
7. Add fuel until it reaches the bottom
of the metal collar supporting the
fuel strainer in the fuel tank
(Fig. 3-1). Take care to not overfill
the tank. It may be necessary to
lower the fuel level depending on
operating conditions.
8. Reinsert the fuel tank cap and tighten.
9. Wipe up any spilled fuel before starting the engine or allow to evaporate.
Spilled fuel is both a fire hazard and an environmental hazard. Dispose of the
fuel soaked rags in a proper hazardous waste container.

ENGINE OIL

NOTICE! Engine oil is a major factor affecting engine performance and service
life. Non-detergent and 2-stroke engine oils will damage a 4-stroke engine and
are not recommended.
High-quality detergent engine oils are acceptable if the (API) performance rating is
SF, SG, SH, SJ or higher. Always check the API service label on the oil container for
the performance rating.
1. Check the oil level before each use with a cool engine that is level.
2. Use 4-stroke motor oil that meets or exceeds the requirements for API
(American Petroleum Institute) service classification SF. Always check the API
Service label on the oil container to be sure it includes the letters SF.
3. Do not use special additives.
4. SAE 10W-30 is recommended for
general, all-temperature use. Other
viscosities shown on the chart may
be used when the average
temperature in your area is within
the indicated range (Fig. 4).
5. Above 27°C (80°F), using 10W-30
oil may increase oil consumption.
Check the oil level more often.
Visit www.princessauto.com for more information
420cc OHV Gas Engine with Electric Start 8449019
3-1
2-1
Fig. 3
Fig. 4
15