Carburetor Adjustment - Power Fist 420cc OHV Mode D'emploi

V 4.4
3. Pour oil into the funnel. Allow the oil to settle for one minute and recheck the
level. Repeat until the desired level is reached.
4. Insert and hand tighten the oil filler cap.
5. Wipe up any spilled oil. Dispose of oil soaked rags in a proper hazardous
waste container.
HOW TO DRAIN OIL
WARNING! Draining oil from the engine may involve tipping it on the side. This
can cause fuel to leak into the oil compartment, creating a potential fire
hazard. Do not tip the engine while draining. If this is unavoidable, drain the
fuel from the engine before draining the oil.
1. Remove the dipstick (O).
2. Place an approved container below the
oil drain plug (Fig. 6).
3. Remove the oil drain plug and allow oil
to the drain into the approved container.
4. Install oil drain plug and tighten with
a wrench.
IMPORTANT! Used oil must be disposed of
properly. Do not pour it on the ground,
down a drain or throw it in the trash. Take the oil to your local recycling centre
or a service station for reclamation.

CARBURETOR ADJUSTMENT

Never make adjustments to the carburetor. The carburetor was set at the factory to
operate efficiently under most conditions. Only a qualified service technician should
adjust the carburetor if it is required.
MODIFYING THE CARBURETOR FOR HIGH ALTITUDES
At high altitude, the standard air-fuel mixture is too rich, causing increased fuel
consumption and decreased performance. A rich mixture will also foul the spark
plug and cause hard starting.
Visit www.princessauto.com for more information
420cc OHV Gas Engine with Electric Start 8449019
O
Fig. 6
17