Troubleshooting - Amica KMI754000C Notice D'utilisation

TROUBLESHOOTING

In the event of any fault:
• Turn off the appliance
• Disconnect the power supply
• Have the appliance repaired
• Based on the instructions given in the table below, some minor issues can be corrected
by the user. Please check the consecutive points in the table before you refer the repair
to customer service.
PROBLEM
1.The appliance does
not work
2.Sensor fields do
not respond when
touched
3.The appliance does
not respond and emits
and extended beep
4.The appliance switch-
es itself off
5.A single cooking zone
switches off and resid-
ual heat indicator „H" is
shown.
6.Residual heat
indicator extinguished
even though the cook-
ing zones are hot
7.Hob cooking surface
is cracked.
8.When the problem is
still not remedied.
9.Induction hob
makes buzzing sound.
1 0 . I n d u c t i o n h o b
makes hissing and
whistling sounds.
11. The hob does not
work. The cooking
zones will not operate.
POSSIBLE CAUSE
- no power
- Appliance is not turned on
- Sensor field touched too briefly
(less than one second)
- Multiple sensors touched at the
same time
- Improper use (wrong sensor fields
touched or sensors touched too
briefly)
- Sensor fields covered or dirty
- No sensor field is touched for 10
seconds of activating the appliance
- Sensor fields covered or dirty
- Limited cook time
- Sensor fields covered or dirty
- Electronic components overheated
- A power outage or the appli-
ance has been disconnected
Danger! Immediately unplug the appliance or switch off the main
circuit breaker. Refer the repair to the nearest service centre.
Immediately unplug the appliance or switch off the main circuit breaker
(fuse). Refer the repair to the nearest service centre.
Important!
You are responsible for operating the appliance correctly and main-
taining its good condition. If you call service as a result of operating the
appliance incorrectly you will be responsible for the costs incurred even
under warranty.
The manufacturer shall not be held liable for damage caused by failure
to follow this manual.
This is normal. Cooling fan is operating to cool down internal electronics.
This is normal. When using several cooking zones at full power, the
hob makes hissing and whistling sounds due to the frequencies used to
power the coils.
- Faulty electronics
- 46 -
REMEDY
-Check the fuse, replace if blown
- Turn on the appliance
- Touch the sensor field longer
- Always touch only one sensor field
(except when a cooking zone is
switched off)
- Reconnect the hob
- Uncover or clean the sensor fields
- Switch on the appliance and set heat
setting without delay
- Uncover or clean the sensor fields
- Switch on the cooking zone again
- Uncover or clean the sensor fields
- Residual heat indicator will be
shown again the next time the ap-
pliance is turned on and off again
- Reset the appliance, unplug it
for a few minutes (disconnect the
fuse).