Install The Hob In The Opening; Tips For The Installer - Amica KMI754000C Notice D'utilisation

Install the hob in the opening

Using an electrical cord, connect the hob according to electrical dia-
gram provided
Remove dust from the worktop, insert hob into the opening and press
in firmly

Tips for the installer

The hob is equipped with a terminal block allowing different connec-
tions appropriate for a specific type of power supply.
Terminal block allows the following connections:
• Single-phase 230V ~
• Two-phase 400V 2N~
The hob can be adapted to a specific type of power supply by bridging
the appropriate terminals according to wiring diagram. Wiring diagram
is placed on the hob's underside. The terminal block can be accessed
by removing the lid on hob's underside. Remember to match the power
cord to the type of connection and the hob's power rating.
Note: Remember to connect the protective conductor to correctly
marked terminal block clamp. The electrical system supplying the hob
must be protected by a properly selected tripping device or a circuit
breaker allowing to disconnect the power supply in an emergency.
Before connecting the appliance to power, please carefully read the in-
formation provided on the rating plate and wiring diagram. Connecting
the hob other than shown on the wiring diagram may damage the hob.
Note: Electrical connection must be made by a properly certified qual-
ified installer. Do not make any alterations in the appliance electrical
system.
Note: The installer is obliged to provide the user with "appliance elec-
trical connection certificate" (enclosed with the warranty card). After
installation, the installer should also provide information on the connec-
tion made:
• single-phase, two-phase or three-phase,
• conductor cross-section,
• electrical protection (fuse type).
- 38 -