Connect The Power Supply; Use A Cooking Zone; Booster Function; Adjust The Heat Setting - Amica KMI754000C Notice D'utilisation

Connect the power supply

When you connect the power
supply, all displays will light up for
about 1 second and you will hear a
beep. The appliance is on.

Use a cooking zone

Place the cookware on the cooking
zone, for example on the rear left
cooking zone. Touch the
and will be shown on all cooking
zone displays. Touch
cooing zone and then use
to select a heat setting 1-9 (some
cooking zones are Booster type -
read on for more details). Touch
the sensor again to confirm the
heat setting or simply wait a few
seconds until it is confirmed auto-
matically. If there is no cookware
on the selected cooking zone, the
symbol will be displayed and the
cooking will only start when you
place the cookware on the cooking
zone.
Note:
You can place the cookware on the
cooking zone at any time, also be-
fore selecting a heat setting for the
cooking zone.
If you do not select a heat setting
within 1 minute, the appliance will
turn off automatically.
When you select a cooking zone
with , a default heat setting of
5 will be displayed and it is not
possible to have a different default
setting.

Booster function

When active, this function tempo-
rarily boosts the power output of a
specific cooking zone. You can set
the heat setting in the range from
1 to P, where P the highest possi-
ble heat setting.
Note: The Booster function can
only operate for a maximum of 5
minutes and then heat setting is
automatically reduced to level 9.

Adjust the heat setting

Touch
cooking zone and then use
to adjust the heat setting 1 to 9
(or 1 to P for the Booster cooking
zones). Touch
new heat setting.
sensor

Turn off a cooking zone

to select a
To turn off a cooking zone touch
and
to select it then proceed as fol-
lows:
•
•
In both cases, touch
simply wait a few seconds.
To turn off all the cooking zones at
once, touch
will turn off completely.

Child Lock

The Child Lock function disables all
touch controls except
symbol is shown on the display.
In order to activate Child Lock
touch and hold
and
vate Child Lock touch and hold
for 3 second and
You can enable Child Lock when
the appliance and the
active. In the event of an emer-
gency, touch
appliance without having to unlock
it first. To turn on the appliance
again you need to deactivate the
Child Lock first.
- 44 -
to select the desired
to confirm the
Touch to reduce the heat
setting down to 0.
Touch and simultaneous-
ly and the heat setting will be
reduced to 0.
and the appliance
for 3 seconds
will be displayed. To deacti-
to turn off the
and
confirm, or
and the
will disappear.
sensor is