Overhead Rigging - Briteq BT-W36L3 WASH Mode D'emploi

ENGLISH
Important: Never look directly into the light source! Don't use the effect in the presence of persons suffering
from epilepsy.
OPERATING INSTRUCTIONS
 Once connected to the mains the device starts running.
 Always unplug the unit when it is not used for a longer time or before to start servicing.
 In the event of serious operating problems, stop using the fixture and contact your dealer immediately.
 Important: Never look directly into the light source! Don't use the effect in the presence of persons
suffering from epilepsy.
FROST FILTER KIT INSTALLATION
Always unplug the unit before installing the frost
filter!
By adding the frost filter to the BT-W36L3, the unit will be
transformed in a real LED WASH moving head in a minute.
The beam angle will be increased while color mixing is improved.
Installing the filter:
 Place the frost filter in front of the head, and insert the quick
fastener inside the hole.
 Press the quick fastener with a gentle knock firmly on the head.
Removing the filter:
 Use a screwdriver to gently loosen the plastic screw of the
quick fastener.
 Remove the filter.

OVERHEAD RIGGING

 Important: The installation must be carried out by qualified service personal only. Improper
installation can result in serious injuries and/or damage to property. Overhead rigging requires
extensive experience! Working load limits should be respected, certified installation materials
should be used, the installed device should be inspected regularly for safety.
 Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging
and servicing.
 Locate the fixture in a well ventilated spot, far away from any flammable materials and/or liquids. The
fixture must be fixed at least 50cm from surrounding walls.
 The device should be installed out of reach of people and outside areas where persons may walk by or be
seated.
 Before rigging make sure that the installation area can hold a minimum point load of 10times the device's
weight.
 Always use a certified safety cable (number 3 on the picture) that can hold 12 times the weight of the
device when installing the unit. This secondary safety attachment should be installed in a way that no part
of the installation can drop more than 20cm if the main attachment fails.
 The device should be well fixed; a free-swinging mounting is dangerous and may not be considered!
 Don't cover any ventilation openings as this may result in overheating.
 The operator has to make sure that the safety-relating and machine-technical installations are approved by
an expert before using them for the first time. The installations should be inspected every year by a skilled
person to be sure that safety is still optimal.
BRITEQ
®
3/83
OPERATION MANUAL
BT-W36L3