Briteq BT-W36L3 WASH Mode D'emploi page 9

ENGLISH
Sound State
The unit works to rhythm of the beat when used in standalone or master/slave mode
 Press the MENU button until "Sound State" is shown on the display.
 Press the ENTER button, the display starts blinking.
 Use DOWN and UP button to select "On" or "Off" mode.
 Once the mode is selected, press the ENTER button save it.
To go back to the main menu without any change press the MENU button shortly.
If you want to go back to normal running mode: press the MENU button for about 2 seconds.
Sound Sense
Used to set the sensitivity of the internal microphone
 Press the MENU button until "Sound Sense" is shown on the display.
 Press the ENTER button, the display starts blinking.
 Use DOWN and UP button to select a value between "0" (very low sensitivity) and "100" (high sensitivity).
 Once the mode is selected, press the ENTER button save it.
To go back to the main menu without any change press the MENU button shortly.
If you want to go back to normal running mode: press the MENU button for about 2 seconds.
Pan Inversion
Normal: Panning movement is not inverted.
Pan inversion: Panning movement is inverted
 Press the MENU button until "Pan inverse" is shown on the display.
 Press the ENTER button, the display starts blinking.
 Use DOWN and UP button to select "No" (normal) or "Yes" (pan inversion) mode.
 Once the mode has been selected, press the ENTER button to save it.
(or automatically return to the main functions without any change after 8 seconds)
To go back to the functions without any change press the MENU button again.
Tilt Inversion
Normal: Tilt movement is not inverted.
Tilt inversion: tilt movement is inverted
 Press the MENU button until "Tilt inverse" is shown on the display.
 Press the ENTER button, the display starts blinking.
 Use DOWN and UP buttons to select "No" (normal) or "Yes" (tilt inversion) mode.
 Once the mode has been selected, press the ENTER button to save it.
(or automatically return to the main functions without any change after 8 seconds)
To go back to the functions without any change press the MENU button again.
Backlight
Backlight on: display is always on.
Backlight off: display is off when not used.
 Press the MENU button until the display shows "Backlight".
 Press the ENTER button, the display starts blinking.
 Use DOWN and UP buttons to select "On" (display always on) or "Off" (display off when not used).
 Once the mode has been selected, press the ENTER button to save it.
(or automatically return to the main functions without any change after 8 seconds)
To go back to the functions without any change press the MENU button again.
Function Delay
On the Function channel (CH7 or CH8) you can select some special functions, like "blackout during
movement". With this option you can select the delay before a selected function becomes active.
IMPORTANT INFORMATION: the function delay can only be set to zero seconds (no Delay) when you are
using a DMX-controller or DMX-software using presets for the DMX-values of the special functions.
Never use "no Delay" while using a simple DMX-controller with faders to set the functions manually!
 Press the MENU button until "Function Delay" is shown on the display.
 Press the ENTER button, the display starts blinking.
 Use DOWN and UP button to select a value between "no Delay" and "3s Delay"
 Once the delay is selected, press the ENTER button save it.
BRITEQ
®
7/83
OPERATION MANUAL
BT-W36L3