Briteq BT-W36L3 WASH Mode D'emploi page 8

ENGLISH
Show 1 mode- Fixture is placed on the floor. Tilt movement angle 210°.
Show 2 mode-Fixture is fixed under ceiling. Tilt movement angle 90°.
Show 3 mode - Fixture is placed on the stage, in front of the audience
The spot is always projecting to the audience's direction; i.e. in front of the stage. Pan movement
angle (left to right to left): 160°. Tilt movement angle: 90° (60° above horizon; 30° below horizon.)
Show 4 mode - Fixture is fixed under ceiling.
The spot is mainly projecting in front of the stage. Pan movement angle (left to right to left):160°. Tilt
movement angle: 90° (vertically, front 75°; back 15°)
Dimmer Curve
This function provides four dimming options:
 Press the MENU button until "Show mode" is shown on the display.
 Press the ENTER button, the display starts blinking.
 Use DOWN and UP buttons to select "Mode 1", "Mode 2", "Mode 3" or "Mode 4".
 Once the right mode shows on the display, press the ENTER button to save it.
(or automatically return to the main functions without any change after 8 seconds)
To go back to the functions without any change press the MENU button again.
Mode 1 (LINEAR): light output varies linearly with the DMX value
Mode 2 (SQUARE LAW ): light output can be adjusted more accurately for low DMX values
Mode 3 (INVERSE SQUARE LAW): light output can be adjusted more accurately for high DMX values.
Mode 4 (S-CURVE): light output can be adjusted more accurately for both high and low DMX values.
Remark: while in 12CH mode you can select FAST or SMOOTH dimming:
 FAST (default setting) the light output changes immediately while changing the DMX value, changing the
dimmer level slowly however might not be perfectly smooth.
 SMOOTH slow changes in the dimmer level are perfectly smooth, however fast changes might appear to
be slower than expected due to some delay.
Slave Mode
Used to make the slave unit work in opposite to the master or to work in complete sync.
 Press the MENU button until "Slave mode" is shown on the display.
 Press the ENTER button, the display starts blinking.
 Use DOWN and UP button to select "Slave 1" (normal) or "Slave 2"opposite.
 Once the mode is selected, press the ENTER button to save it.
(or automatically return to the main functions without any change after 8 seconds)
To go back to the functions without any change press the MENU button again.
Blackout Mode
Blackout mode: when no DMX-signal is detected, the unit goes in blackout and waits for the DMX-
signal.
No blackout mode: when no DMX-signal is detected, the unit automatically switches to standalone
mode.
Freeze mode: when no DMX-signal is detected, the unit freezes with the latest dmx values received
and waits for the DMX-signal.
 Press the MENU button until "Black out" is shown on the display.
 Press the ENTER button, the display starts blinking.
 Use DOWN and UP button to select "Yes" (yes blackout), "No" (no blackout) mode, "Freeze" mode.
 Once the mode has been selected, press the ENTER button to save it.
(or automatically return to the main functions without any change after 8 seconds)
To go back to the functions without any change press the MENU button again.
BRITEQ
®
6/83
OPERATION MANUAL
BT-W36L3