Briteq BT-W36L3 WASH Mode D'emploi page 10

ENGLISH
To go back to the main menu without any change press the MENU button shortly.
If you want to go back to normal running mode: press the MENU button for about 2 seconds.
White balance
It allows the user to fine tune the three colors to achieve the perfect white
 Press the MENU button until the display shows "White balance".
 Press the ENTER button, the display starts blinking.
 If you want to change the default settings, press the DOWN and UP buttons to select "RED", "BLUE" or
"GREEN".
 Press ENTER and modify the values to set a specific color temperature, confirm with ENTER.
(or automatically return to the main functions without any change after 8 seconds)
To go back to the functions without any change press the MENU button again.
Dimmer Calibrate
Due to tolerances in the production process, not all LEDs have exactly the same brightness,
therefore you can use this option to match the Brightness of different machines.
 Press the MENU button until "Dimmer Calibrat" is shown on the display.
 Press the ENTER button, the display starts blinking.
 Use DOWN and UP buttons to select a value between "50" (lowest brightness) and "100" (highest
brightness).
 Once the brightness is selected, press the ENTER button save it.
To go back to the main menu without any change press the MENU button shortly.
If you want to go back to normal running mode: press the MENU button for about 2 seconds.
Manual Test
Used to manually check all functions of the unit.
 Press the MENU button to show "Manual test" on the display.
 Press the ENTER button, the display starts blinking.
 Use the DOWN and UP button to select the "Pan", "Tilt", "Red", "Green", "Blue", "Dimmer" or "Strobe"
mode.
 Press the ENTER button, the display starts blinking.
 Use the DOWN and UP button adjust the value from 0 to 255 to test the unit.
To go back to the main menu without any change press the MENU button shortly.
If you want to go back to normal running mode: press the MENU button for about 2 seconds.
Temp.
Used to show the temperature inside the unit
 Press the MENU button until the display shows "Temp.".
 Press the ENTER button to show the internal temperature of the unit on the display.
 To go back to the functions press the MENU button again.
If you want to go back to normal running mode: press the MENU button for about 2 seconds.
Note: The unit is equipped with a temperature protection to avoid damage to the LEDs while working under
heavy conditions in venues with high temperatures. When the temperature of the LEDs reaches 50°C, the
light output will slightly reduce while the display shows: "HIGH LED TEMP: 50°
If, for some reason, the temperature of the LEDs would reach a temperature over 60°C, the output will shut
down while the display shows: " LED OFF, OVERTEMP "
Fixture time
Used to show the number of working hours of the unit.
 Press the MENU button until "Fixture time" is blinking on the display.
 Press the ENTER button to show the number of working hours in the display.
To go back to the functions press the MENU button.
Firmware version
Used to show the Firmware version installed in the unit
 Press the MENU button until " Firmware version" is blinking on the display.
 Press the ENTER button to show the software version on the display.
To go back to the functions press the MENU button.
BRITEQ
®
8/83
OPERATION MANUAL
BT-W36L3