cecotec CONGA 3390 Manuel D'instructions page 31

ENGLISH
Pause
During robot operation, press pause on the App to stop it, and press clean to resume cleaning.
Standby
The robot will automatically enter standby mode after 5 minutes of no operation.
Press clean on the App to activate it again.
Note:
After 12 hours of no operation, the robot will turn automatically off.
The robot will not enter standby mode during charging.
Suction power level
Press the suction power level function on the App to set the desired power level.
Choose between Eco (low power), Medium (medium power) and Turbo (high power).
Schedule
The robot is provided with a schedule function in order to provide a maximum-efficiency
cleaning. The time settings and the cleaning scheduling must be carried out from the App.
Once the robot has been scheduled, it will automatically carry out the cleaning cycles every
scheduled day.
Note: Make sure the robot is activated and that the light indicator is lighted before scheduling
any cleaning or setting time.
Light indicator:
Operating: Steady blue light
Low power: Orange light blinks slowly
Charging: Orange light oscillates
Network configuration: Blue light blinks slowly.
Start-up/firmware update: Blue light oscillates
Error: Red light flashes quickly
Modes
The first time the robot is operated, it will map and save the whole house's map by means of
its laser before starting the cleaning cycle.
Use the robot in Auto mode and Eco power level, this way you will ensure the robot memorizes
the full map.
Note: Make sure the light indicator is lighted in blue before starting cleaning, indicating it is
activated. If not, press any button on the App to activate it.
30