Battery Replacement - oventrop Aktor MH CON B ENOCEAN Notice D'installation Et D'utilisation

Battery replacement

6. Battery replacement
When the batteries are empty (valve in emergency position), LED 2 will flash
alternately green and red. This signal is still visible through the viewer even if
the casing cover is closed.
1. Remove the casing cover. Push down both release tabs and remove the
cover at the same time.
2. Remove the empty batteries. The mounted actuator can be turned so that
the battery case is easily accessible.
Actuator
Aktor MH CON B
3. Press the "teach in"/adjustment button (A)
after having removed the batteries in order
to discharge the electronics.
4. Insert new batteries. Both LEDs will flash green (see flash codes).
5. Mount the casing cover onto the actuator until it engages audibly.
After having removed the batteries, an automatic "adjustment run" will be
X
carried out by the actuator and the radio communication between the
actuator and the Smart Home System will be restored.
This can take several minutes.
"Aktor MH CON B (ENOCEAN)"


Casing cover


11/12
Release tabs

Viewer
LED 2
A
No rechargeable
batteries!