oventrop Aktor MH CON B ENOCEAN Notice D'installation Et D'utilisation page 17

Technical description
The wireless actuator supports two variants for radiator control according to
the EnOcean radio profile "EEP A5-20-01":
• The actuator activates the radiator valve (valve lift 0-100%) according to
the instructions of an external Smart Home System.
• The actuator receives an actual and a nominal temperature value
(0-40°C) for a room from an external Smart Home System. The actuator
uses its internal control function for the calculation of the valve lift.
The wireless actuator should be operated in this mode.
Main functions for control operation
No Function
1 Adaptation
2
Installation
3
Removal
Frost
4
protection
Factory
5
setting
Emergency
6
operation
7
Valve protection
Additional functions (must be supported by the Smart Home System)
No Function
1
Summer mode
Service function 1
2
"Open valve"
Service function 2
3
"Close valve"
Service function 3
4
"Carry out calibration"
5
Communication test
Condition
Press "teach in" button (A)
briefly < 3 sec.
Hold "teach in" button (A)
> 3 sec.
Hold "teach in" button (A)
> 3 sec.
Actual temperature below
6°C
See chapter 7
Failure of
Smart Home System
No valve activation for 14 days
Transmission interval increased to 30 minutes
Valve is controlled remotely and is opened
Valve is controlled remotely and is closed
A calibration is carried out by the actuator
remotely and independent of control operation
5/12
"Aktor MH CON B (ENOCEAN)"
Connection to Smart Home Sys-
tem, drive shaft (S) closes the valve
Drive shaft (S) closes the valve
Drive shaft (S) opens the valve;
actuator can be removed from
the valve more easily
Drive shaft (S) opens the valve up
to the frost protection position
Drive shaft (S) retracts, valve fully
open, assignment between actua-
tor and Smart Home Sys. gets lost
Control is carried out by the
actuator sensor (21°C)
Valve opens and closes automatically
Effect
independent of control operation
independent of control operation
See paragraph 3.4
Effect