oventrop Aktor MH CON B ENOCEAN Notice D'installation Et D'utilisation page 21

Installation and initial operation
IMPORTANT NOTE
If the "teach in"/adjustment button is pressed too long, an automatic manual
adjustment of the actuator will be triggered (see paragraph 5.1). Please note
that the "teach in" process will not have been completed successfully. At this
stage, the actuator has not yet been detected by the Smart Home System
and cannot be identified via the user interface (see above).
Should a manual adjustment run have been carried out, the "teach in"/ad-
justment button has to be pressed (briefly) again to carry out the adaptation
to the Smart Home System.
A triple red flashing of the LEDs of the wireless actuator (see flash codes) sig-
nalizes that the "teach in" process has not been completed successfully. The
following could be the reasons:
• The "teach in" process has not been triggered at the Smart Home
System before.
• The radio connection is disturbed or the radio range is restricted, for
instance because of unfavourable spatial conditions. This problem can
be solved by using wireless repeaters for signal amplification
(e.g. RP-S F, OV item no. 1150699).
A triple red flashing of the LEDs of the wireless actuators also signalises that
the adjustment has not been completed successfully. The following could be
the reason:
• The closing dimension of the valve is < 11 mm.
• The valve is blocked or stiff.
6. Mount the casing cover onto the actuator until it engages audibly.
"Aktor MH CON B (ENOCEAN)"
9/12