Safety Checks; General Safety Check; Electrical Safety Check; Start-Up/Working - Stiga 320 P Manuel D'utilisation

(Translation of the original instructions)
7.6

SAFETY CHECKS

When testing the machine, verify that the results
of the safety checks match the results in the
following tables.
Always carry out the safety checks be-
fore use.
If any of the results fails to match the
indications provided in the following
tables, do not use the machine!
Take it to a service centre to be
checked and repaired if necessary.

7.6.1 General safety check

Object
Fuel lines and
connections.
Electrical cables
Unloading system. No losses in connection
Oil lines
Drive the machine
forwards and in re-
verse and release
the drive pedal.
Test driving

7.6.2 Electrical safety check

Status
The parking
brake pedal is not
pressed.
Engine running.
7.7

START-UP/WORKING

When using the machine, the bonnet
must be closed and locked.
Always use full gas when using the
machine.
When starting the machine wait 2 sec-
onds in the start position before start-
ing the engine.
Result
No leaks.
All insulation intact.
No mechanical damage.
points. All screws are tight.
No leaks. No damage.
The machine stops.
No abnormal vibrations.
No abnormal sound.
Action Result
Try to start it. The engine
does not
start.
The operator The engine
gets up from stops.
the seat.
ENGLISH
1. Open the fuel stopcock (22).
2. Check that the spark plug leads are inserted
into their spark plugs.
3. Disconnect the power socket (12:A).
4. Do not keep your foot on the service/drive
brake pedal (11:D).
Cold start
For 2WD models
1. Put into gear (14:A1).
For 4WD models
1. Put into gear (15:A1-B1).
Engage the parking brake (11:B)
2.
Move the accelerator to full throttle (12:E).
3.
4. Close the choke (12:G1) (if applicable).
5. Turn the ignition key and start the engine.
Before operating the machine, wait a
few minutes to allow the oil to heat up.
Hot start
For 2WD models
1. Put into gear (14:A1).
For 4WD models
1. Put into gear (15:A1-B1).
2. Engage the parking brake (11:B)
3. Move the accelerator to full throttle (12:E).
4. The choke control must be pressed (12:G2)
(if applicable).
5. Turn the ignition key and start the engine.
To continue see the instructions given
in paragraph 7.7.1.

7.7.1 Run

To operate with the machine proceed as de-
scribed below:
• Fully press the pedal down (11:B) and release
it.
• Press the pedal (11:D) to drive the machine.
• Move to the work area.
• If front attachments are installed, activate the
power socket (12:A).
• Start work.
EN
17