lamber L25-ek Instructions D'emploi page 11

Self-washing cycle: with machine on, carry out the
following operations:
- Remove the overflow from the tank and wait
for the tank's emptying (for machines with
drain pump, look at the instructions in the
specific paragraph),
- Close the hood of the dishwasher,
- Keep pressed the cycle button ''C'' during 3
seconds: lamp ''2'' flashes during all the length
of the 5 or 10 minutes cycle, according to the
rinse's duration fixed by default.
F
– Extract the basket inclining it and shake it
carefully, so that the remaining drops can fall down.
Leave the dishes in the basket until they will be dry by
evaporation. Take the dishes away from the basket
and pay attention not to touch the dishes internally on
its border and put them on clean shelves.
In order to continue the washing, load another basket
and close the hood. The cycle will automatically start
again.
ACHIEVEMENTS
Any deficiency in the washing process is obvious
when dirty residuals are visible. Any halos might be
caused by an insufficient rinsing: in this case, check
that the rinsing jets are clean and that there is a
sufficient pressure in the water distribution network.
In case you find residuals, check that:
• the washing jets are clean
• there is some detergent
• the pump suction filter is clean
• objects in the rack are placed in a correct position.
DISHES POSITIONING
It is suitable to place dishes inside the plastic basket
with the concave side facing upwards. (see draw).
RINSING ADDITIVES
To grant a perfect rinsing, a quick drying and to avoid
calcareous sediments on glasses and cups you must
add a surfactant on water (Brightener).
Your cleansing agent supplier will be able to suggest
the most suitable product. Your machine is equipped
with a rinse aid dispenser. Mean concentration used
is 0,15 g/lt.
Adding Rinse Aid and Detergent
CAUTION: Only use detergent and rinse aid which
are suitable for commercial washers, a non-foaming
industrial alkaline detergent.
Do not use any soap intended for a residential
dishwasher. This leads to large amounts of foam
building up in the washer and will void your
manufacturers warranty.
CAUTION: Detergents for commercial dishwashers
cause corrosion. Always follow the instructions on the
packaging and drums.
CAUTION: Do not mix different detergent products,
this could cause the dosing pump to break down due
to crystallization.
NSF 3-2009 requirements for detergent and
chemical sanitizer dispensers
Feeders (rinse-aid, or detergent) are OPTIONAL.
When provided see instructions on page 28 in this
manual.
DRAIN PUMP INSTRUCTIONS
(only for machines with drain pump)
The drain pump works automatically only
during the washing cycle to discharge the
exceeding water coming from the rinsing cycle.
At the end of the working day, in order to
completely discharge the tank, it is necessary
to perform the following operations:
1. Open the hood of the dishwasher
2. Remove the overflow pipe from the tank;
3 . Afterwards push button "F" for 3 seconds.
Control lamp "E" and the cycle lamp (the last
chosen) are flashing alternatively.
The discharge will stop automatically after 5
minutes. Control lamps will stop flashing.
The drain can be stopped at any time by pressing
again button ''F'' .
Please note: in case the hood is open the control
lamp "E" will continue to flash.
Reinstall the overflow and shut the hood.
10