Assembly Mini - YAKINIKU KAMADO Serie Manuel D'instructions

6.4. ASSEMBLY MINI

IMPORTANT! - Remove all packaging before use, but keep the safety
instructions and keep them with this product. Make sure the lid is closed
before assembly.
1
2
STEP 1
STEP 3
STEP 1 - Insert the screw (B) through the hole of both Cart legs (1,2) and then
tighten the cap nuts (A) by hand.
(Note: The screws should be facing downwards).
STEP 2 - Use 2 screws and 2 cap nuts to manually install the Steel carrier
handle (3) to the base. Then repeat this step on the other side of the frame.
STEP 3 - Tighten all 6 screws with the wrench.
STEP 4 - Lift the kamado out of the box and place it in the assembled stand.
3
STEP 2
STEP 4
48
A
B
1
Cart leg 1 (1x)
2
Cart leg 2 (1x)
3
Steel carrier handle (2x)
A
Cap nut (9x)
B
Screw (M6x12mm) (9x)
EN