YAKINIKU KAMADO Serie Manuel D'instructions page 43

IMPORTANT! - Remove all packaging before use, but keep the safety
instructions and keep them with this product. Make sure the lid is closed
before assembly.
6
5
1
A
C
STEP 1 - Attach 4x long gaskets/adhesive pads (5) and 4x short gaskets/adhesive
pads (6) to the 4x upright leg sections (1) as shown. Make sure the long gasket
(5) is attached to the inside of the angled leg section and the short gasket (6)
is attached to the end of the upright leg section (1).
STEP 2 - Attach a castor wheel (3 and 4) to each upright leg section (1) by
pushing the pre-attached bolt on the castor wheels (3 and 4) through the hole
in the upright leg section (1), add the washer (B) and secure with 1 x cap nut
(A). Tighten with included wrench. Repeat process for all leg sections (1).
STEP 3 - Insert 2x cross brackets (2) into open cross of 1 x upright leg (1) with
the flat side to the swivel. Place 2 x screws (C) in each cross bracket (2) to hold
them in place. Do not tighten all the way.
STEP 4 - Loosely attach 3x remaining upright leg sections (1) to the cross
brackets (2) with 12x screws (C), ensuring that the 2x castor wheels with
brakes (3) are together on the front of the assembled stand. Make sure the
gaskets (5 and 6) are facing up.
STEP 5 - Tighten all 16 screws (C) with a Phillips screwdriver to ensure the
stand is sturdy and stable.
43
2
3
or
4
B
EN