Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
V4.0
low voltage at the motor, motor connections are not correct or the load is too
heavy. Check the motor current after a few minutes of operation and compare
the measured current with the nameplate rating.
CARE & MAINTENANCE
1.
Maintain the tool with care. A tool in good condition is efficient, easier to
control and will have fewer problems.
2.
Inspect the tool components periodically. Repair or replace damaged or
worn components. Only use identical replacement parts when servicing.
3.
Follow instructions for lubricating and changing accessories.
4.
Maintain the tool's labels and name plates. These carry important information.
If unreadable or missing, contact Princess Auto Ltd. for replacements.
WARNING! Only qualified service personnel should repair the tool. An
improperly repaired tool may present a hazard to the user and/or others.
CONDENSATE DRAINS
The motor comes with one way sintered brass breather drains. These drains
allow the motor to expel liquids from the casing without allowing liquid to enter
the motor.
The drains may require periodic maintenance to keep them clean of debris and
flowing freely. Occasionally, remove the brass drains and wash them
thoroughly. Eliminate any built up debris that may be impeding their operation.
For motors that are equipped with rubber plugs in their condensate drain holes,
be sure to remove the plug, especially if the motor is installed in a location
where condensate build up is likely.
In all instances, ensure that the drain is in the lowest portion of the motor.
Some motors may require rotation of the end plates (e.g. if the mounting
location is not a typical horizontal mounting).
LUBRICATION
The bearings are permanently lubricated and do not require additional grease.
Visit www.princessauto.com for more information
1-1/2 HP Totally Enclosed Air Over Electric Motor
8703159
9
Publicité
Table des Matières
