General Description; Safety Instructions; Power Connection - Eneo VKC-1361/IR-4.0 Mode D'emploi

Installation and Operating Instructions
1/3" Day/Night Camera with LED Illumination
VKC-1361/IR-4.0

1. Safety Instructions

• Read these safety instructions and the operation manual first before you
install and commission the camera.
• Keep the manual in a safe place for later reference.
• P rotect your camera from contamination with water and humidity to prevent
it from permanent damage.
Never switch the camera on when it gets wet. Have it checked at an
authorized service center in this case.
• Never operate the camera outside of the specifications as this may prevent
the camera functioning.
• Do not operate the cameras beyond their specified temperature, humidity or
power ratings.
Operate the camera only at a temperature range of -10°C to +50°C and at
a humidity of max. 90%.
• To disconnect the power cord of the unit, pull it out by the plug.
Never pull the cord itself.
• P ay attention when laying the connection cable and observe that the cable
is not subject to heavy loads, kinks, or damage and no moisture can get in.
• Do not attempt to disassemble the camera board from the dome.
• The warranty becomes void if repairs are undertaken by unauthorized
persons.
Do not open the camera housing.
• Maintenance and repair have to be carried out only by authorized service
centers.
Before opening the cover disconnect the unit from mains input.
• The fitter is responsible for the system of protection being followed in
accordance with the technical data, e.g. by sealing of the cable outlet with
silicone.
• Contact your local dealer in case of malfunction.
• Only use original parts and original accessories from Videor E. Hartig GmbH.
• Do not use strong or abrasive detergents when cleaning the housing.
Use a dry cloth to clean the camera surface.
In case the dirt is hard to remove, use a mild detergent and wipe gently.
NOTE: This is a class A digital device. This digital device can cause
harmful interference in a residential area;
in this case the user may be required to take appropriate
corrective action at his/her own expense.

2. General Description

• Weatherproof CCD Camera with IR Illumination
• 1/3" Sony SS-HQ1 CCD Sensor
• Integrated 4.0mm/F2.0 Lens
• Sensitivity of 0.18Lux (F1.2)
• Approx. 15m Illumination Range, 850nm LEDs
• B&W Display at Night Time and IR LED Illumination
• Automatic Shutter Control (ESC)
• Automatic White Balance (ATW)
• Aluminium Housing with Sunshield
• Protection Rating IP67
• Supply Voltage: 12VDC
• Sunshield and Wall Mount Bracket supplied
3. Installation
1) Install the camera bracket on the ceiling or wall.
2) Mount the camera body to the bracket.
Make sure light sensor for IR LED should be located at upside.
Top or bottom mount is possible depending on the installation site.
In case of top mount, the mount bracket is installed over the sunshield.
3) Connect Video and Power and apply the power.
4) Set the camera angle and tighten the bracket
5) Mount the Sun-shield on the camera body.
Screw for sunshield must be fastened tight enough to avoid a breakaway.
6) Remove the protective film attached in window cover after installation

4. Power connection

Connect DC plug to DC jack first and then plug the AC adapter to the AC outlets
to avoid the damage from the surge voltage charged when no load.
WARNING !
12VDC regulated power supply is highly recommended.
Power supply should be capable of 4 watts output.