Safety Instructions; General Description - Eneo EDC-IPS-1 Mode D'installation

Table des Matières

Les langues disponibles

1. Safety instructions

• Read these safety instructions and the operation manual first before you install and commission the camera.

• Keep the manual in a safe place for later reference.

• Protect your camera from contamination with water and humidity to prevent it from permanent damage. Never switch the camera on when it gets wet.

Have it checked at an authorized service center in this case.

• Do not operate the cameras beyond their specified temperature, humidity or power ratings.

• Operate the camera only at a temperature range of -10°C to +50°C and at a humidity of max. 90%.

• To disconnect the power cord of the unit, pull it out by the plug. Never pull the cord itself.

• Pay attention when laying the connection cable and observe that the cable is not subject to heavy loads, kinks, or damage and no moisture can get in.

Do not attempt to disassemble the camera board from the dome.

• The warranty becomes void if repairs are undertaken by unauthorized persons.

• Use a dry cloth to clean the dome surface. In case the dirt is hard to remove, use a mild detergent and wipe gently.

Note: This is a class A digital device. This digital device can cause harmful interference in a residential area; in this case the user may be required

to take appropriate corrective action at his/her own expense.