General Description; Safety Instructions - Eneo VKC-1371/IR-6 Mode D'emploi

Installation and Operating Instructions
1/3" Day/Night Camera with LED Illumination
VKC-1371/IR-6, VKC-1371/IR-3.6

1. Safety Instructions

• Read these safety instructions and the operation manual first before you
install and commission the camera.
• Keep the manual in a safe place for later reference.
• P rotect your camera from contamination with water and humidity to prevent
it from permanent damage.
Never switch the camera on when it gets wet. Have it checked at an
authorized service center in this case.
• Never operate the camera outside of the specifications as this may prevent
the camera functioning.
• Do not operate the cameras beyond their specified temperature, humidity or
power ratings.
Operate the camera only at a temperature range of -10°C to +50°C and at
a humidity of max. 90%.
• To disconnect the power cord of the unit, pull it out by the plug.
Never pull the cord itself.
• P ay attention when laying the connection cable and observe that the cable
is not subject to heavy loads, kinks, or damage and no moisture can get in.
• The warranty becomes void if repairs are undertaken by unauthorized
persons. Do not open the camera housing.
• Never point the camera towards the sun with the aperture open.
This can destroy the sensor.
• Make sure the sensor is not covered !
• Installation, maintenance and repair have to be carried out only by
authorized service centers.
Before opening the cover disconnect the unit from mains input.
• The fitter is responsible for the system of protection being followed in
accordance with the technical data, e.g. by sealing of the cable outlet with
silicone.
• Contact your local dealer in case of malfunction.
• Only use original parts and original accessories from Videor E. Hartig GmbH.
• Do not use strong or abrasive detergents when cleaning the dome.
Use a dry cloth to clean the dome surface.
In case the dirt is hard to remove, use a mild detergent and wipe gently.
• During assembly, care must be taken to ensure that existing seals are
correctly inserted and are not displaced as a result of assembly.
You must not continue to use damaged seals.
NOTE: This is a class A digital device. This digital device can cause
harmful interference in a residential area; in this case the user
may be required to take appropriate corrective action at his/her
own expense.

2. General Description

• Weatherproof Day&Night CCD
• Super HAD II CCD Sensor
• Sensitivity of 0.22Lux at F1.2 (Colour)
• B&W Display at Night Time and IR LED Illumination
• IR Illumination by 30 integrated 850nm LEDs
• Approx. 30m Illumination Range
• Camera Automatic Shutter Control (ESC)
• Automatic White Balance (AWB)
• Supply Voltage: 12VDC
• Aluminium Housing with Sunshield
• Protection Rating: IP67
• Mounting Stand with Cable Concealed through Bracket
3. Installation
Cable concealed through bracket (option)
When using the cable conceales bracket, it is not able to install on the ceiling.
4. Connection
Connect DC plug to DC jack first and then plug the AC adapter to the AC outlets
to avoid the damage from the surge voltage charged when no load.
BNC Female Video Out
ATTENTION !
12VDC regulated power supply is highly recommended.
Assemble a fixing screw.
Video In
DC + 12V Male
12VDC regulated
Power Supply