General Description - Eneo VTL-W/N2 Instructions De Montage

2. General Description

• Camera weatherprotection (VTL-W/N2, Art.-Nr. 79484)
Dust proof housing (VTL-D/N2, Art.-Nr. 79485)
• For wall mount (VTL-W/N2, Art.-Nr. 79484)
For ceiling mount (ceiling mount bracket Included) (VTL-D/N2, Art. No. 79485)
• Fold-down housing body
• Housing body length: 00 mm
• Insulated camera mounting
•  Cable entries
• 0V Window heater included (VTL-W/N2, Art. No. 79484)
• Protection rating: IP66
3. Installation
ATTENTION
Ensure that the mains is switched off before attempting to work with the housing.
Fig. 1
Fig. 2
. Fasten in the requested position the bracket (X) using
8mm screws with the suitable rawlbolts (fig. ).
. Loosen the screw (A) and unscrew the two screws (B)
with 4mm Allen key (fig. ).
For easier access to the screws (B) push the
sunshield forward.
. Slide the body of the housing.
Disconnect the earth connection.
The body hangs and can be removed totally by
pulling the pins (C) out of the rails (D) (fig. ).
4. Route tha cables inside the glands (E) (fig. ).
5. Make the electrical connections.
6. Install the camera with screw and the insulating
washer (fig. ).
7. To close the housing please proceed in the reverse
direction of the opening.
Replace the body, make the earthing, fasten the body
to back part, lock the screw (A) of the external slide.
8