V-Check Points Lite; T_Sen1: Thermal Sensor Connectors; Jdash1 : Tuning Controller Connector - MSI MEG Z590 UNIFY Présentation Rapide

V-Check Points Lite

These voltage checkpoints are used to measure the current system voltages. A
multimeter (not included) will be required to check voltages. To measure voltage,
place test leads on the GND (screw mounting hole) and a specific V-Check Point.
Please refer to the manual of your multimeter for more information.

T_SEN1: Thermal Sensor Connectors

This connector allows you to connect the thermistor cable and use it to monitor the
temperature of the detection point.

JDASH1 : Tuning Controller connector

This connector is used to connect an optional Tuning Controller module.
GND
VCCIO
VCCSA
DRAM
VCORE
VCCIO2
Sense
GND
1 No Pin
3 MCU_SMB_SCL_M
5 VCC5
7 PSIN#_R
9 OC_RETRY#
11 BLK+
13 CLRCMOS_EN
Thermistor cable
2 14
1
13
2
4 MCU_SMB_SDA_M
6 Ground
8 FP_RST#_R
10 OC_FS
12 BLK-
14
Overview of Components
NC
NC
31