W_Flow1: Water Flow Meter Connector; T_Sen1: Thermal Sensor Connector; V-Check Points Lite - MSI Creator X299 Présentation Rapide

W_FLOW1: Water Flow Meter Connector

This connector allows you to connect a water flow meter to monitor the flow rate of
your liquid cooling system.

T_SEN1: Thermal Sensor Connector

This connector allows you to connect the theral sensor cable and use it to monitor the
temperature of the detection point.

V-Check Points Lite

These voltage checkpoints are used to measure the current system voltages. A
multimeter (not included) will be required to check voltages. To measure voltage,
place test leads on the GND (screw mounting hole) and a specific V-Check Point.
Please refer to the manual of your multimeter for more information.
32
Overview of Components
1 Ground
2 WFLOW PWR
Sense
GND
VCCIN
VSA
GND
VCCIO
VCC_DDR
CORE
RING
1
3 WFLOW IN
Thermistor cable