Pentair A5300 Mode D'emploi page 5

INTERNET AND ALERTS CONFIGURATION
INTERNET CONNECTION AND ALERTS CONFIGURATION
1. Complete the Battery Backup Registration, Internet
Connection and Alert Configuration BEFORE connecting
the battery and AC power supply to your BBU.
NOTE: If you have already connected the battery and
AC power supply to the BBU before connecting to to the
internet, complete the device registration process.
Then disconnect the battery and remove the AC power
supply from the BBU panel and gateway for 2 minutes in
order to reset the panel. Resume with Step 8.
2. Download the Pentair Home app to your mobile device
from the App Store® or Google Play™ Store.
3. Open the app.
EXISTING USERS: LOGIN to your account.

NEW USERS: Scroll down in the App and click SIGN

UP.
4. Enter a valid EMAIL and PASSWORD.
5. Select TERMS OF SERVICE.
6. Click CREATE AN ACCOUNT.
7. Complete instruction in the VERIFICATION EMAIL
8. LOGIN to your account.
9. Register your device using the Unique Device ID Key
included on the device and your manual cover.
10. The Alerts will use the e-mail(s) and phone number(s)
entered here.
11. Find an open network connection on your internet router
or other hardwired connection (like an internet switch).
12. Rotate the Gateway antenna up on the gateway. Using
Gateway Status
Green Power on. Gateway connected to servers.
Green, quick blink Power on. Data traffic to servers.
Green, slow blink Power on. Gateway connected to local router, but not
(1-2 blinks per second) connected to Internet or servers.
Red Power on. Gateway has no local connection to
router. The gateway does not recognize/see that it is
connected to the router.
Red, slow blink Power on. Gateway communicating with router, but
(1-2 blinks per second) router cannot assign Dynamic Host Configuration
Protocol (DHCP) or Domain Name System (DNS) to
gateway.
Off Power off or product fault.
SIM979 (06-08-20)
13. Connect the Gateway to the open internet port
14. An uninterrupted power supply for your internet modem,
15. Connect the Gateway power supply to a 115 VAC outlet, plug
16. Connect the red positive (+) charger/controller lead wire to the
17. Connect the black negative (-)charger/controller lead wire to
18. Connect the Charger Power Supply cable (supplied) to the
19. Check the AC power LED on the Controller. If it is solid green
20. Verify the system is operational by pressing the TEST
21. Test communication by clicking the Test icon on the web page
22. Using the drop down menu, configure the desired method of
23. Alerts can be tested by activating the pump with thefloat
Definition
TABLE I: GATEWAY TROUBLESHOOTING
the supplied 1 meter Ethernet cable (or a longer cable if
necessary)
home router and the gateway power supply is recommended.
the cord into the back of the Gateway.
The Gateway will blink red for a few seconds.

When the LED becomes solid Green or solid Green with

an occasional blink – your Gateway is communicating with
the Link2O server. If not, refer to Gateway Trouble in the
manual.
positive (+) (red) battery terminal.
the negative (-) (black) battery terminal.
Charger/Controller's Power input jack. Plug the other end into
a 115 VAC outlet.
the unit is communicating with the web site.
SYSTEM button and observing the test sequence.
and verify the unit has run the test.
Alerts you want to receive: text or email.
switch.
Action Needed
OK - Connection complete and operational
OK - Operating, data is moving between BBU and server
System is online and scanning for destination/server
(add a network switch inline to help define unit).
Check Ethernet cable connections and/or quality or
cable. Try a different router port. Is the router turned on.
Router is not permitting the gateway to access the
internet (add a network switch inline to help define unit).
Check power source, verify power adapter is
functioning. Defective gateway.
5