Installation; Basic Configuration; Start Up - Kärcher RDS1 Mode D'emploi

Installation

Assembly must be carried out by a qualified
specialist.
The RDS1 must be switched on to ex-
change information between the washing
bay and the mobile phone.
Gantry plant
1 On / Off switch
2 RDS1 module
The installation takes place in a separate
control cabinet.
Self-service plant
1 On / Off switch
2 RDS1 module
The installation directly takes place in the
control cabinet of the system.
WARNING
Risk of damage!
Make the electrical connections according
to the circuit plan.
 Connect antenna.
 Insert SIM card (subscriber identity
module).
 Connect system communication.
 Switch on the supply voltage.
10
 Connect RDS1 to the configuration PC
via an ethernet cable.
Note:
Briefly push the SIM card in order to re-
move it. The card is then pushed out a bit
and can be removed. Switch off the RDS1
module via the On/Off switch prior to re-
moval.

Start up

Note:
A standard PC with the following minimum
specifications is required for the configura-
tion:
– WIndows 7
– Web-Browser (Internet Explorer / Fire-
fox)
– Ethernet / LAN connection
LAN settings on the configuration
PC
Adjustment only necessary if no DHCP cli-
ent is active on the PC (option obtain IP ad-
dress automatically is switched off).
 Open control panel.
 Open network and sharing centre.
 Select LAN connections and properties.
 Select internet protocol version 4 (TCP/
IPv4) and properties.
 Enter IP address.
IP address:
192.168.1.2
Subnet mask:
255.255.255.0
Default gateway:
192.168.1.1
Preferred DNS server:
192.168.1.1
Connecting with the RDS1 module
 Open the browser on the configuration
PC.
 Enter the IP address 192.168.1.1 in the
address bar.
 Enter user name and password. Stand-
ard: insys / icom.
2
-
EN

Basic configuration

 Selecting the language.
 Select GSM / GPRS.
 Enter PIN (the PIN is assigned by the
SIM card provider).
 Confirm entry with "OK".
 Select system / sandbox.
 Select activate sandbox.
 Select option "Reserve interface serial
1 for sandbox".
 Select option "Reserve I2C-interface for
sandbox".
 Confirm entry with "OK".