2. Insert saw blade 1 into slot in reciprocating plunger and
tighten clamp screw.
Working with the tool
Only sharp saw blades in good condition will provide satis-
factory cutting performance and prevent the tool being
overloaded. For this
reason, promptly replace blunt saw blades.
1. Switch on tool at switch 2 (Fig. 3) and set the appropria-
te speed for the work at knob 1.
Never use excessive pressure. Only the correct, uniform
number of strokes per minute provide optimum cutting per-
formance.
Wood, aluminium, brass, and sheet metal
= high number of strokes/min
Plastics, thin materials, precision work
= low number of strokes/min
Working with the ball head cutter
It is recommended to use the ball head cutter (fig. 1, pos. 7)
when working with spherically or irregularly shaped surfa-
ces, such as when cutting out hulls, pumpkins, or similar
(see fig. 4). To do so, simply remove the fastening screw
and pull off the sliding block and, as shown in fig. 5, repla-
ce it with the ball head cutter. You must screw the faste-
ning screw back in.
Maintenance
Only the reciprocating plunger may be lightly oiled.
1. Regularly lubricate reciprocating plunger with several
drops of engine oil, after approx.
30 min. running time (Fig. 6).
2. Following each use, clean attached saw dust from tool
using a dry paintbrush.
Disposal:
Please do not dispose of the device in domestic waste! The
device contains valuable substances that can be recycled.
If you have any questions about this, please contact your
local waste management enterprise or other corresponding
municipal facilities.
Important
Note:
Important
EC Declaration of Conformity
Name and address:
PROXXON S.A.
6-10, Härebierg
L-6868 Wecker
Product designation:
Article No.:
In sole responsibility, we declare that this product conforms
to the following directives and normative documents:
EU Machinery Directive 2014/30/EC
DIN EN 55014-1/05.2012
DIN EN 55014-2/02.2016
DIN EN 61000-3-2/03.2015
DIN EN 61000-3-3/03.2014
Date: 07.11.2016
Dipl.-Ing. Jörg Wagner
PROXXON S.A.
Machine Safety Department
The CE document authorized agent is identical with the
signatory.
STS 12/E
28534
- 9 -