Pentair MAGICSTREAM LAMINAR Guide D'installation page 9

Operating MagicStream Laminars in Standard Mode
®
To access the Standard Mode setting, you must cycle the power to the MagicStream Laminar with
®
16 Off/On sequences. To return to the IntelliBrite Mode, cycle the power Off/On with 17 sequences.
When in Standard Mode, turning the switch Off and On a specific number of times, the light
activates one of the three light show modes or locks a chosen color.
Selecting a color light show mode or fixed color
Switch power on to the MagicStream laminar. A random color will flash indicating the program you
are in, followed by the previously selected program mode. To select a color show mode or fixed
color, turn the wall switch off/on a specific number of times. Please review the chart below and
follow the power cycle sequence to activate the various show feature effects while in "show" modes.
1. Fixed Color: Turn power off and then on to "Hold" the Light on that specific color (no matter
what color show you are in). If you keep the unit on that color for at least five (5) seconds, the
MagicStream laminar will "save" this color and keep it in that mode until you release it with an
additional power off/on sequence. In "Fixed Color" mode the light when powered on, will not flash
its program, but immediately go to the "Fixed Color" chosen.
2. Color Show Mode: Turn power off and then on twice (Off/On, Off/On) to cycle through the
following three color modes. Turning the power on and off twice (Off/On, Off/On) will continue to
cycle through the programs.
Synchronized Mode: All MagicStream laminars on the same circuit will synchronize and cycle on the
same colors. When the units are in this mode, when powered up, the light will flash a random color
one time and then turn all units on white and then start cycling through the eight colors. The single
flash of a random color is the visual confirmation what color show you have activated. The light will
stay in this mode each time the system is powered on until a program change is made. Colors will
change at 10 sec intervals.
Random Mode: Turn the power on and then off twice (Off/On, Off/On) and the light will cycle to the
next program, Random Mode. In this mode each of the MagicStream laminars will cycle together,
but in random colors. When this mode is selected, the light will flash twice to indicate it is in random
mode and then start up in a random color sequence. If multiple lights are on the same circuit,
each light will display different random colors. Colors will change at about 10 sec intervals but in a
completely random sequence. In this mode, multiple Laminars will NOT change colors together.
Party Mode: Turn the power on and then off twice (Off/On, Off/On) and the light will cycle to the
next program, Party Mode. In this mode each of the MagicStream laminars will cycle together, but
in random colors and in ever increasing cycle speeds until the last ten seconds at which time the
MagicStream laminars will randomly flash different colors at different times. When this mode is
selected, the light will flash three times to indicate it is in Party Mode and then start up in a random
color sequence. If multiple lights are on the same circuit, each light will display different colors.
Colors will change randomly and slowly at first, then speed up, until the sequence ends with quick
flashes and strobes. The sequence then repeats, beginning with the slow changes. In this mode,
multiple laminars will NOT change color together.
9