Pentair MAGICSTREAM LAMINAR Guide D'installation page 15

REPLACING THE MAGICSTREAM
The following removal and installation instructions describe how to remove and install the MagicStream
Laminar assembly. Also use these instructions after completing the following light replacement procedure.
Failure to bring the pool or spa's electrical system up to code requirements before installing the
light will create an electrical hazard which could result in death or serious injury to pool users,
installers, or others due to electrical shock, and may also cause damage to property.
1. Switch off electrical switch or circuit breaker at the source.
2. Remove Junction Box or Transformer cover. Disconnect the light wires and attach a fish tape to
the existing light power cord. This will assist in pulling the replacement light power cord through
the conduit back to the junction box.
3. Remove the MagicStream laminar assembly from the housing.
4. Slowly pull the light and attached power cord (with attached fish tape) out of the housing. Pull
the light's power cord and fish tape out of the housing and place the light on the deck.
5. Attach the new light power cord to the fish tape and carefully feed the fish tape and cable to the
junction box.
6. Feed cord through housing then through conduit to Junction Box or 12 Volt AC Transformer. The
MagicStream laminar has no serviceable parts, so leave approximately 1 to 1.2 meter of cord to
allow the light to be easily removed if replacement is required.
7. Cut the cord at the Junction Box or 12 volt AC transformer, leaving at least 15 cm (6 inches) of
cord to make connections.
8. Strip back 5cm of the outer cord jacket to expose the two insulated wires (be careful not to
damage the insulation on the two (2) inner wires).
9. Connect both (2) wires to the corresponding circuit wires in the Junction Box or 12 Volt AC
Transformer and secure the Junction Box cover in place.
10. Install the MagicStream laminar assembly into the niche and tighten the two screws provided.
(AFTER ELECTRICAL REQUIREMENTS ARE MET)
LAMINAR ASSEMBLY
®
15