Pentair MAGICSTREAM LAMINAR Guide D'installation page 5

MagicStream Laminar Overview
®
This manual describes how to install and replace the MagicStream
laminar provides brilliant vivid multi-colors with spectacular lighting effects for your pool and
spa. The energy efficient colored LED array utilizes IntelliBrite
cycle through colors at varying speeds and in different sequences of colors. Choose one of the
seven pre-programmed color light shows or select one of the five fixed colors to create virtually
endless range of dramatic underwater lighting effects for a spectacular effect in your pool and spa.
The LED Light Engine controls the operation of the following features, and its built-in memory capability
ensures that each time you turn the light engine on, it resumes operation with the same features in
operation as when you last turned it off:
If multiple types of IntelliBrite LED lights are being used, all lights connected to the same transformer
will be working together.
Operating Modes (Standard and IntelliBrite)
There are two operating settings built-in the MagicStream laminar, Standard Mode and IntelliBrite
Mode. The default factory setting is IntelliBrite Mode. Use the Standard Mode setting if you wish to
be compatible with legacy laminars without IntelliBrite Mode capability. If there is a MagicStream
laminar model installed in your pool or spa that does not support the IntelliBrite Mode feature, reset
the MagicStream laminar to Standard Mode to match the existing set up. To access the Standard Mode
setting, you must cycle the power to the MagicStream laminar with 16 off/on sequences. To return
to the IntelliBrite Mode setting, cycle the power 17 off/on sequences.
Operating MagicStream
The MagicStream laminar can be controlled using a standard wall-mount light switch. Multiple
MagicStream laminars can be connected via a junction box to a single switch so that all lights can be switched
on and off together. The lights are controlled by cycling the AC power to the power supply and from there
to the lights from a standard wall switch. By turning the switch OFF and ON a specific number of times, the
light activates one of the seven light show modes, fixed colors, or enables the "Hold" and "Recall" feature.
Note: Wall switch must be connected to the 220 VAC side of the transformer and never to the 12
VAC side.
Operating MagicStream
MagicStream laminar can also be automatically controlled via Pentair IntelliPool
the IntelliBrite "Circuit Function". For more information refer to the IntelliPool Control System User's Guide.
Laminars Using a Wall Switch
®
Laminars Using Automation Control System
®
5
Laminar. The MagicStream
®
Color LED Light technology and can
®
Control Systems, utilizing
®