Maintenance And Troubleshooting - Pentair MAGICSTREAM LAMINAR Guide D'installation

Maintenance and Troubleshooting

The following information describes how to service and maintain the MagicStream® Laminar
Filter Cleaning
Perform routine maintenance on the filter to ensure trouble-free Laminar operation. Be careful to keep
debris out of the discharge plumbing when cleaning the filter. If debris gets into the filter discharge line to
the laminar, follow this procedure:
1. Remove the laminar by unscrewing the two deck housing lid retaining screws.
2. Remove the deck housing lid and laminar unit and place on the deck.
3. Disconnect the supply union and turn on the Laminar supply pump until the water runs clear.
4. Reattach the union, place the laminar back in the deck housing and check the alignment of the
stream.
5. Replace the deck housing lid retaining screws.
Clogged Laminar (Poor Stream Quality)
If the laminar orifice becomes clogged with debris, follow this procedure:
1. Remove the Laminar by unscrewing the two deck housing lid retaining screws.
2. Remove the deck housing lid and Laminar unit and place on the deck. Disconnect the supply
union.
3. Using a garden hose, place the hose over the jet nozzle and force water backward through the
unit and out the 3/4" open union. This will clear most of the debris.
NOTE: Do not insert anything into the laminar orifice! This may permanently damage the laminar
stream.
The external flexible cable or cord of this luminaire cannot be replaced; if the cord is damaged, the lumin-
The entire LED unit can be replaced. Check Spare parts section – partnumber 590021-EU – Laminar LED
LIMITED WARRANTY : 2 YEARS
Further details :
www.pentairpooleurope.com
aire LED engine shall be destroyed.
light engine.
20