Pentair MAGICSTREAM LAMINAR Guide D'installation page 7

Operating MagicStream
MagicStream Laminars
telliBrite Controller. Multiple
®
VAC transformer to a single switch so that all lights can be switched on and off together.
Stream laminars are controlled by cycling AC power to the 12 VAC transformer from a stan-
dard wall switch. By turning the switch Off and On a specific number of times, the light activates
one of the seven light show modes, fixed colors, or enables the "Hold" and "Recall" feature.
Note: Wall switch must be connected to the 220 VAC side of the transformer and never to the 12 VAC side.
Powering on the MagicStream Laminar
When the MagicStream laminar
displayed.
Note: If power to the light is off for more than five (5) seconds, the last color show mode or fixed color
that was saved will be displayed.
Selecting Color Show Mode or a Fixed Color using a Wall Switch
MagicStream Laminars are compatible with IntelliBrite light colors and shows and can be
synchronized with IntelliBrite color lights. First switch power on to the light; the previously
selected color show mode or fixed color is displayed. To select a color show mode (1-7) or fixed
color (8-12), rapidly turn the wall switch Off/On a specific number of times. Each number (1-17)
shown below corresponds to the number of times to power-cycle the switch to activate a color
light show or fixed color. For details about saving color effects while in Show modes, see "Hold"
and "Recall" feature.
1 SAm Mode: Cycles through white, magenta, blue and green colors (emulates the Pentair
SAm® Color Light).
2 Party Mode: Rapid color changing building energy and excitement.
3 Romance Mode: Slow color transitions creating a mesmerizing and calming effect.
4 Caribbean Mode: Transitions between a variety of blues and greens.
5 American Mode: Patriotic red, white and blue transition.
6 California Sunset Mode: Dramatic transitions of orange, red and magenta tones.
7 Royal Mode: Richer, deeper color tones.
8 Blue: Fixed color.
9 Green: Fixed color.
10 Red: Fixed color.
11 White: Fixed color.
12 Magenta: Fixed color.
13 Hold: Save the current color effect during a color light show.
14 Recall: Activate the last saved color effect.
15 White
16 Standard Mode
17 IntelliBrite Mode
Laminars Using a Wall Switch
®
can be controlled using a standard wall-mount light switch or by the In-
MagicStream laminars
is powered on, the previously selected color show mode or fixed color is
can be connected via a junction box and 12
7
Magic-