Pentair MAGICSTREAM LAMINAR Guide D'installation page 19

Light Enhancer Setup (darkness required)
You may elect to vary the intensity of the light when using the LED light source to light the laminar
stream. You can adjust the light intensity by means of the light enhancer. The light enhancer uses
a very small stream of water to add very small bubbles to the stream. The screw that controls the
light enhancer is located on the Laminar orifice plate (Figure 6).
Figure 6
There is no optimal setting for the light enhancer, and the intensity of the light emitting from
the laminar stream is purely a matter of taste. We encourage you to experiment with the light
enhancer to achieve the effect you desire.
NOTE: Laminars are sensitive to wind, earth movement and equipment vibration. Secure the Laminar and Deck Housing
to minimize vibration. Periodic stream distortion, caused by pump vibrations and motor electrical fluctuations, is normal and
not indicative of a nozzle defect.
NOTE: A Laminar may occasionally "burp" as a result of trapped air accumulating in the nozzle body.
This phenomenon is normal and will occur until all air is purged from the piping system. Trapped air can
also cause slight distortion in water action. It is imperative that all air is removed to ensure proper water feature operation.
Control screw
Light
enhancer
19