Pentair MAGICSTREAM LAMINAR Guide D'installation page 8

Example: To select California Sunset Mode; First switch power on to the light; the previously
selected color show mode or fixed color is displayed, then rapidly turn the switch off and on six (6)
successive times. During the Off/On switching process, no illumination will occur.
Which Mode the Light is in? Turn the switch Off/On 17 times to reset the light to IntelliBrite Mode,
fixed on white, Random Mode off and Thumper on. From there you can set the desired mode.
Random Mode
The MagicStream Laminar has an additional Random Mode. In Random Mode the lights will randomly
®
transition through the same color palette as in IntelliBrite Mode at a similar speed to the IntelliBrite
Mode. As an example, lights in American Mode display a pattern of red, white and blue, while lights in
IntelliBrite Random Mode and American Mode will display the same colors, but each light will display
them in a random order. The speed of the transitions is also tied to the IntelliBrite Mode. Sam Mode
will change colors slowly and Party Mode will change more rapidly.
Activating IntelliBrite Random Mode: To toggle IntelliBrite Random Mode On or Off you need to enter
Party Mode(Off-On-Off-On), wait until the lights come on and then enter Party Mode a second time
(Off-On-Off-On) with less than 30 seconds between them (Off-On-Off-On) (Wait for light to come on)
(Off-On-Off-On) (Wait for light to come on).
Solenoid Thumper
The solenoid thumper feature creates a "wrinkle" in the laminar stream creating a brilliant spot of light
in the laminar arc. Toggle the Thumper On or Off by entering Party Mode 3 times in less than 30 sec-
onds... (Off-On-Off-On) (Wait for light to come on) (Off-On-Off-On) (Wait for light to come on) (Off-On-
Off-On) (Wait for light to come on)
All modes, except random, thump every 4 seconds except for Party Mode which thumps every 2
seconds. Random Mode thumps randomly every 1 to 3.5 seconds.
Resetting All Lights: To Reset all the lights you need to enter Party Mode four (4) times with less than
30 seconds between them. This will turn IntelliBrite Random Mode OFF. This is needed because should
two lights ever get into different states, toggling their states will never fix the problem (Off-On-Off-On)
(Wait for light to come on) (Off-On-Off-On) (Wait for light to come on) (Off-On-Off-On) (Wait for light to
come on) (Off-On-Off-On) (Wait for light to come on).
Saving a color mode or fixed color
When power is switched off to the MagicStream laminars, the last color show mode or fixed
color will be saved. The next time the light is powered on, the previously saved color show
mode or fixed color will be displayed. For example, while in Party Mode switch the light off.
Wait more than 10 seconds, switch the light back on to resume Party Mode.
8