Pentair MAGICSTREAM LAMINAR Guide D'installation page 11

Selecting a MagicStream
Controller
Instead of using a wall switch, MagicStream
controlled with the IntelliBrite Controller (sold separately).
The IntelliBrite controller provides complete control of
your MagicStream laminars when in IntelliBrite Mode. The
IntelliBrite controller can control individual or multiple 12
VAC transformers to control MagicStream laminars. Multiple
MagicStream laminars can be connected via a junction box
to the Controller so that all lights can be switched on and off
together. The IntelliBrite controller can also control multiple
MagicStream laminars and IntelliBrite lights.
Using the IntelliBrite Controller: MagicStream laminars are compatible with IntelliBrite colors and
shows and can be synchronized with IntelliBrite color pool/spa and landscape lights. To select a color
light show mode or fixed color mode, rotate the dial so that it points to the desired selection. The
color mode selections start in a clockwise direction from the
9 o'clock position.
Hold and Recall Feature
Note: When MagicStream laminars are powered on, the previously selected color show mode or fixed
color is displayed.
Hold button/LED: Press this button (LED on) to capture and save a color effect while displaying one of
the light show modes. When the button is pressed, the LED will be on, indicating that the color effect
is captured.
Recall Button/LED: Use this button (LED on) to activate the last saved color effect. When the button is
pressed, the LED will be on, indicating that the color effect is being displayed.
Activating IntelliBrite Random Mode: To toggle IntelliBrite Random Mode On or Off you need to enter
Party Mode, wait until the lights come on turn the dial one notch and then enter Party Mode a second
time with less than 30 seconds between them.
Activating Solenoid Thumper: The solenoid thumper feature creates a "wrinkle" in the laminar stream
creating a brilliant spot of light in the laminar arc. Toggle the Thumper On or Off by entering Party
Mode 3 times in less than 30 seconds. For example, turn the dial to Party Mode, wait until the lights
come on, turn the dial one notch and then back to Party Mode and repeat a third time within 30
seconds.
Resetting All Lights: To Reset all the lights you need to enter Party Mode four (4) times with less than
30 seconds between them. This will turn IntelliBrite Random Mode OFF. This is needed because should
two lights ever get into different states, toggling their states will never fix the problem.
There are two ways to issue the commands with an IntelliBrite controller. You can switch to Party
Mode and then turn the lights on and off using the Green button the desired number of times or you
can switch back and forth between Party Mode and Sam Mode the desired number of times. Both
methods require you to wait until the lights come back on before repeating the procedure. If the lights
are not within sight of the controller, waiting 10 seconds between each change also works.
Laminar show mode or fixed color using an IntelliBrite
®
Laminars can
®
11
®
IntelliBrite Controller
®
PRINTED ON: 7/29/2009, 600054_ctlg pics.SLDASM