Adjustment Mode - LaserLiner Centurium Express G Mode D'emploi

Adjustment mode

1. Take the alignment of the rotary laser into account when
performing adjustment work. Always adjust all the axes.
2. Switch the device to adjustment mode:
Switch off the rotary laser. Simultaneously press the ON/OFF button
and the auto/man button until the auto/man LED flashes rapidly. You
can then release both buttons.
The X-axis is set first (X LED flashes) in horizontal mode
(X/Y-axis). You can switch between X and Y-axis with the TILT button
on the rotary laser (Y LED flashes).
Only the Z LED flashes in vertical mode (Z-axis).
3. Correcting the adjustment:
Use the positioning buttons on the rotary laser to move the laser
from its current position to the level of the reference point A2.
The laser only changes its position by pressing the buttons several
times.
4. Completing the adjustment:
Cancel:
Save:
Regularly check the adjustment before
!
use, after transport and after extended
periods of storage. Always make sure
to control all axes.
Manual_Centurium_Express_G_Rev20W43_DE_FR.indd 29 Manual_Centurium_Express_G_Rev20W43_DE_FR.indd 29
Switch the rotary laser off (via the ON/OFF button) to
reject all adjustment settings and restore the previous
status.
The new adjustment settings are saved by pressing
the positioning button (rotate to the right).
Centurium Express G
Z
X- / Y- /
Z-axis
Y
X
29
EN
21.10.20 08:5 21.10.20 08:5