Operation Symbols; Quickstart Label Symbols - Champion Power Equipment 100379 Manuel De L'opérateur

100379 - FRONT TiNE TiLLER

Operation Symbols

Some of the following symbols may be used on this product. Please study them and learn their meaning. Proper interpretation of these
symbols will allow you to more safely operate the product.
SYmBol
Choke lever
ChoKE: left position
run: right position
Fuel Valve
CloSED: left position
oPEn: right position
Throttle lever
FaST: left position
Throttle lever
SloW: right position

Quickstart Label Symbols

Some of the following symbols may be used on this product. Please study them and learn their meaning. Proper interpretation of these
symbols will allow you to more safely operate the product.
Starting the Engine
1. Check Oil Level. Recommended oil is 10W-30. The engine can
be seriously damaged without oil. Always check the oil level
before using. The machine must be resting firmly on level
ground when checking.
2. Add gasoline with a minimum octane rating of 85 and an
ethanol content of less than 10% by volume.
3mm corner radius; 2mm safe margin
3. Move the choke lever to "ChoKE" position.
4. Move the throttle lever to "FaST" position.
This artwork belongs to Champion Power Equipment. The contents are confidential and privileged and shall not be disclosed to or used by or for
outside parties without the explicit consent of Champion Power Equipment.
5. Move the fuel valve to "oPEn" position.
6. Pull starter cord.
7. Move the choke lever to "run" position.
mEaninG
1 2 3
10W-30
5 6
LPN 2197-L-OP
Rev A
Size 75 x 35 mm
Artwork Notes
9
iMPORTANT SAFETY iNSTRUCTiONS
SYmBol
Forward
reverse
Engage Tines
Disengage Tines
Stop
4 1
2
7
2197-L-OP-A
Stopping the Engine
in an emergency, turn the engine switch to the "oFF"
position.
Colors
under normal operation:
1. Turn the fuel valve to the "oFF" position.
K 152 CG1
2. Let the engine run until fuel starvation has stopped the
Revision Changes
engine. This usually takes few minutes.
---
important: Always ensure that the fuel valve is in the "oFF"
position when the engine is not in use.
mEaninG
186 ---