Install The Guard Extension; Outer Tine Assembly; Forward/Reverse Clutch Lever Assembly - Champion Power Equipment 100379 Manuel De L'opérateur

Rotoculteur à dents à l'avant
Masquer les pouces Voir aussi pour 100379:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

100379 - FRONT TiNE TiLLER

install the Guard Extension

1. Mount the side guard extensions as shown - slide guard
extension in and lock in place for each side.
2. Attach using the (6) M5 bolts and (6) flanged lock nuts. Three
sets for each side.

Outer Tine Assembly

1. Remove the "B" clips (A) from the pins (B).
2. Remove the pins (B) from the tine spacer (C)
A
b
C
14
3. Insert the tine spacer (C) into the end of the inner tine shaft
which is already assembled to the unit. Align the holes on the
tine spacer (C) with the holes on the inner tine shaft. Insert
the pin (B) through the holes on the tine spacer and the inner
tine shaft. Secure the pin with the "B" clip (A).
4. Install the outer tine onto the tine spacer (C). Align the holes
on the tine spacer and the outer tine shaft. Insert the pin (B)
through the holes on the tine spacer and the outer tine shaft.
Secure the pin with the "B" clip (A).
5. Repeat steps 1 – 4 above for the other side.
b
C
A

Forward/Reverse Clutch Lever Assembly

1. Using a 5mm hex wrench, remove the M6 × 20 bolts from the
clutch levers.
F
F
2. Your clutch levers and tiller handles are marked with "R"
(reverse) and "F" (forward). Ensuring that you have these
matched up, place the bottom clutch lever holder (with cable
attached) on the bottom of the tiller handle while placing the
upper clutch lever holder on the top of the tiller handle.
ASSEMbLY
R
R

Publicité

Table des Matières
loading

Table des Matières