Troubleshooting - Champion Power Equipment 100379 Manuel De L'opérateur

100379 - FRONT TiNE TiLLER

TROUbLESHOOTiNG

Problem
Engine does not start
Engine runs poorly
Engine overheats
Engine does not shut off
Wheels and Tines will not turn
Tines turn, but wheels don't
Wheels Turn, but tines don't
Poor tilling performance
Cause
Spark plug wire disconnected.
Engine Throttle Control Lever incorrectly
set.
Fuel tank empty.
Choke control (if so equipped) in
incorrect position.
Stale gasoline.
Dirty air filter.
Defective or incorrectly gapped spark
plug.
Carburetor out of adjustment.
Misadjusted throttle control.
Dirt or water in fuel tank.
Defective or incorrectly gapped spark
plug.
Dirty air filter(s).
Carburetor out of adjustment.
Stale gasoline.
Dirt or water in fuel tank.
Engine cooling system clogged.
Engine cooling system clogged.
Carburetor out of adjustment.
Oil level is low.
Misadjusted throttle control or ignition
switch.
Improper use of controls.
Worn, broken, or misadjusted drive
belt(s).
Internal transmission wear or damage.
Bolt loose in transmission pulley.
Wheel Drive Pins not in WHEEL DRIVE.
Bolt loose in transmission pulley.
Internal transmission wear or damage.
Tine holder mounting hardware missing.
Bolt loose in transmission pulley.
Internal transmission wear or damage.
Worn tines.
Improper Depth Regulator setting.
Incorrect throttle setting.
Forward Drive Belt slipping.
38
TROUbLESHOOTiNG
Solution
Reconnect wire.
Put lever in START position.
Add fuel.
Move to CHOKE position.
Drain fuel and add fresh fuel.
Clean or replace filter.
Inspect spark plug.
Contact Technical Support Team.
Contact Technical Support Team.
Contact Technical Support Team.
Inspect spark plug.
Clean or replace.
Contact Technical Support Team.
Replace with fresh gasoline.
Contact Technical Support Team.
Clean air cooling system.
Clean air cooling area.
Contact Technical Support Team.
Check oil level.
Contact Technical Support Team.
Review controls section.
See "Checking and Adjusting Forward Drive Belt
Tension" or "Belt Tension Adjustment".
Contact local dealer or the factory.
Tighten bolt.
See "Wheel Drive Pins".
Tighten bolt.
Contact Technical Support Team.
Replace hardware.
Tighten bolt.
Contact Technical Support Team.
See "Tines" section.
See "Depth Regulator Lever Adjustment".
Adjust throttle on engine or speed control on
handelbar to highest setting.
See "Checking and Adjusting Forward Drive Belt
Tension" or "Belt Tension Adjustment".