Assembly; Unpacking; Wheel Assembly; Install Lower Handle - Champion Power Equipment 100379 Manuel De L'opérateur

100379 - FRONT TiNE TiLLER

ASSEMbLY

Your tiller requires some assembly. This unit ships from our factory
without oil. It must be properly serviced with fuel and oil before
operation.
If you have any questions regarding the assembly of your tiller, call
our Technical Support Team at 1-877-338-0999. Please have your
serial number and model number available.

Unpacking

1. Set the shipping carton on a solid, flat surface.
2. Remove everything from the carton except the tiller.
3. Carefully cut each corner of the box from top to bottom.
4. Fold each side flat on the ground to provide a surface area to
work with the tiller.

Wheel Assembly

1. While holding the washer (A) and spring (B) in place,
using needle nose pliers, remove the "R" clip (C) from the
wheel adjust bracket (D) (if spring is not held in place, the
compression could cause the spring and washer to be lost).
2. After "R" clip (C) is removed, gently release the tension on the
washer (A) and spring (B) and remove them from the wheel
adjust bracket. Remove the wheel adjust bracket (D) from the
wheel bracket assembly.
D
3. Insert the wheel bracket assembly into the rear frame of the
tiller.
4. Insert the long end of the wheel adjust bracket (D) into the
bottom rear hole of the frame of the tiller, through the wheel
bracket assembly and out of the other side of the unit frame
while also inserting the short end of the wheel adjust bracket
through the top hole on the unit frame and seating it into one
of the holes of the wheel bracket assembly.
C
A
b
E
13
5. Place the spring (B) back onto the long pole of the wheel
adjust bracket (D). Place the washer (A) onto the long pole of
the wheel adjust bracket (D). Carefully compress the washer
and spring to get them past the hole for the "R" clip (C).
Insert the "R" clip (C) into the hole to secure the pieces to the
unit.
b
C
A
E
b
A
C

install Lower Handle

1. Mount lower handles onto tiller body using the (2) M8 bolts,
(4) flat washers, (2) lock washers, and (2) M8 lock nuts.

install Upper Handle

1. Mount upper handle using (2) M8 round head bolts, (2) flat
washers, and (2) knobs.
ASSEMbLY
D
D