Install Speed Control; Add Engine Oil; Add Fuel - Champion Power Equipment 100379 Manuel De L'opérateur

100379 - FRONT TiNE TiLLER
3. Replace the M6 × 20 bolts and tighten with the 5mm hex
wrench.
F
F
F

install Speed Control

1. Mount speed control assembly to upper handle bar using (1)
M6 bolt, (1) flat washer and (1) M6 lock nut.

Add Engine Oil

1. Place tiller on a flat, level surface.
2. Put the wheels in the WHEEL DRIVE position.
3. Remove oil fill cap/dipstick to add engine oil.
4. Using a funnel, add up to 16.9 fl. oz. (500 ml) of oil and
replace oil fill cap/dipstick. DO NOT OVERFILL.
5. Check engine oil level and add as needed.
MAX
R
R
R
OIL DIP STICK
15
Recommended Engine Oil Type
5W-30
5W-30 Synthetic
°F
-20 0 20
°C -28.9 -17.8 -6.7 4.4
Ambient temperature

Add Fuel

1. Use clean, fresh, regular unleaded gasoline with a minimum
octane rating of 85 and an ethanol content of 10% or less by
volume. y b c
2. DO NOT mix oil with gasoline.
3. Remove the gasoline cap.
4. Slowly add gasoline to the tank. DO NOT OVERFILL.
Gasoline can expand after filling. A minimum of ¼ in. (6.4 mm) of
space left in the tank is required for gasoline expansion although
more than ¼ in. (6.4 mm) is recommended. Gasoline can be
forced out of the tank as a result of expansion if overfilled and can
affect the stable running condition of the tiller.

Use regular unleaded gasoline with a minimum octane rating
of 85 and an ethanol content of 10% or less by volume.
DO NOT mix oil and gasoline.
Fill tank to approximately ¼ in. (6.4 mm) below the top of the
tank to allow for gasoline expansion.
DO NOT pump gasoline directly into the tiller at the pump. Use
an approved container to transfer the gasoline to the tiller.
DO NOT fill tank indoors.
DO NOT fill tank when the engine is running or hot.
DO NOT overfill the tank.
DO NOT light cigarettes or smoke when filling the tank.
ASSEMbLY
10W-30
10W-40
40 60 80 100
15.6 26.7 37.8
CAUTiON
120
48.9