Extinction; Adjusting The Operating Power; Adjusting The Set Temperature - Invicta P642151 Manuel D'utilisation

WARNING: If the ignition does not start, an "Ignition error" alarm will sound and the [NO IGNITION] message will
appear on the screen.
Before making a second attempt, completely empty all the fuel from the burner that was used in the first
attempt.
NOTE: Before igniting and in the following cases, you must empty all accumulated fuel from the burner:
After each ignition failure.
–
If the extinction phase that interrupts the ignition phase has been programmed.
–
When reigniting the appliance, check to see if there are any leftover pellets.
–
WARNING: For safety reasons, never return used pellets into the tank.

Extinction

7.6
To turn off the appliance, press and hold [P4]. The message [FINAL
CLEANING] will appear on the screen.
The auger will stop. The smoke extractor will stay on until the
appliance has completely cooled down. Then, it will turn off and the
[OFF] message will appear on the screen.
WARNING: Never stop the appliance by unplugging it or using the switch: Short-circuiting the shutdown cycle
may damage the heater or cause problems with reigniting the appliance.

Adjusting the operating power

7.7
The appliance has 5 operating powers that are managed automatically.
From the main screen, you can adjust the operating power (between 1
and 5) using [P5] and [P6]. To increase the power, press [P6]. To
decrease, press [P5]. The selected power level appears on the screen.
To exit the selection, do not touch the control panel for 5 seconds, or
press [P4].
The operating power can automatically be regulated between the
minimum (Power 1) and the selected maximum (between 1 and 5)

Adjusting the set temperature

7.8
This is the desired temperature in the room where the unit is installed. It is measured by a wire probe that is fixed in an
area away from the radiation of the appliance. (See section 2.1)
•
"Left smoke outlet" hopper, wire probe on the bottom right.
•
"Right smoke outlet" hopper, wire probe on the bottom left.
To adjust the room temperature, press [P1] or [P2].
The screen shows the room temperature [ROOM-TEMP DISPLAY].
Press [P2] to decrease the set room temperature and press [P1] to
increase the set room temperature. After about 5 seconds, the value is
saved, and you will be returned to the main screen. To exit this screen,
press [P4].
SP 06 04 2018
Poêle Cannelé Plug-in
Références P642151 & P642152
Page 20 sur
47