Charging A Mobile Phone; Undok App; Additional Metal Telescopic Antenna - PERFECTPRO ROCKPRO Mode D'emploi

CHARGING A MOBILE PHONE

The USB socket on the right hand side can provide DC power of 5V/0.5A for charging a
mobile phone. Connect the mobile phone to the USB socket with an appropriate cable
(not included with Perfectpro Rockpro). The USB power is available in all the operating
modes and including standby mode. Refer to the user manual or the manufacturer of
the mobile phone to verify if it supports charging from an USB power.
Warning: Never use the USB socket in rainy or moist conditions to prevent moist from
entering the radio and so to prevent potential short circuit. Always keep the rubber cover
well closed under these conditions.
It is recommended to use AC power while charging a mobile phone via USB socket.
On battery power it is also possible to charge a mobile phone from the USB socket,
however using battery power to charge a mobile phone will consume much energy from
the battery and so drain the battery fast.

UNDOK APP

The Perfectpro Rockpro supports remote control from Apple iPhone, iPad and
Android using the UNDOK app. The apps are available in Apple's app store and
Google's android play.
The UNDOK app allows you to:
Control all the modes of the Perfectpro Rockpro, including internet radio, Spotify,
Media Player, USB playback, DAB, FM, Bluetooth and AUX-In;
Adjust the volume level of current playback;
Setting EQ for various audio presets;
Setting Sleep timer;
Editing the displayed name of the Prefectpro Rockpro.

ADDITIONAL METAL TELESCOPIC ANTENNA

You can use this as an alternative antenna for your radio in areas or locations where the
radio signal (FM/DAB/DAB+) is weak to very weak.
ATTENTION: The standard antenna on the radio is flexible. The metal antenna
is not flexible or bendable and should be used with care. Breaking or bending
antennas is not covered by warranty.
Installing: Carefully screw off the standard exible antenna. First carefully loosen the
antenna with an open-end-wrench (size 14) – turn counter clockwise.
Carefully screw on the metal telescopic antenna and softly tighten it with an open-end
wrench key (size 14) – turn clockwise.
ATTENTION: do not use too much force when fixing the antennas as this can
damage the screw threat of the antennas or make it break off.
37