Power The Radio; Charging The Batteries - PERFECTPRO Rock Mate 2 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Power the radio

1. Installing the batteries, first turn battery cover fixture anti-clockwise to loosen and pull down
the battery cover.
Note:
Before you insert the batteries, if you use non-rechargeable batteries, make sure the NiMH/
Alkaline switch is switched to Alkaline position.
. Insert 6 x C size (UM-) batteries into the compartment. Ensure the batteries are completely
inserted in accordance with the diagram shown. Close the battery cover and fasten the fixture
by turning clockwise. If the radio is not to be used for any extended period of time, it is recommended
that the batteries are removed from the radio. Reduced power, distortion and a "stuttering sound",
or low battery sign
flashing on the LCD display are all signs that the batteries need replacing
or recharging (see below Charging the batteries). Run time of the radio on batteries varies
strongly depending on the quality and capacity (mAh) of the batteries, temperature, volume
level etc.
. AC Operation
Before plugging the AC power cord into the AC socket, be sure the voltage is correct. If you
have batteries in the radio and connect AC power cord into the AC socket, the batteries will
automatically be disconnected. AC cable hook is designed to store the cord when the radio is
not in use.

Charging the batteries

Reduced power, distortion and a "stuttering sound" or low battery sign flashing on the LCD display
are all signs that the batteries need recharged if you use rechargeable batteries to power the radio.
Note:
The radio can be charged only when the radio is off. Connect the AC power cord into the AC
socket to charge the batteries. Be sure the battery type switch is set to Ni/MH position. When the
batteries are being charged, the red Charge LED will be on. Charging time can take up to approx.
0 hours depending on the battery capacity of the rechargeable batteries. When the batteries are
fully charged, the charged LED will be steady on green color.
Note:
Charge new batteries fully the first time before first use. This can take longer depending on the
capacity of the rechargeable batteries.
7

Publicité

Table des Matières
loading

Table des Matières