Power Supply; Lithium Battery Operation And Charging - PERFECTPRO ROCKPRO Mode D'emploi

POWER SUPPLY

AC OPERATION
1. Before plugging the AC power cord into the AC mains power socket, be sure the
voltage is correct.
2. Never use the AC power cord in rainy or moist conditions to prevent short circuit or
moist from entering the radio. Under those conditions only use battery power and
keep all rubber covers well closed.
NOTE:
In order to disconnect the radio from the AC mains power completely, the AC power
cord should be removed from the AC mains power socket completely and it shall remain
readily operable and should not be obstructed during intended use.
In case of malfunction due to electrostatic discharge or fast transient (burst), remove
the AC power cord from AC mains power socket and reconnect the power supply after
approximately one minute.

LITHIUM BATTERY OPERATION AND CHARGING

NOTE ON FIRST USE : BEFORE OPERATING THE Perfectpro Rockpro FOR THE
FIRST TIME ALWAYS FIRST FULLY CHARGE THE LITHIUM BATTERY.
The Perfectpro Rockpro can be operated by the built-in Lithium battery. During
operation on battery power the approximate power level of the battery is displayed by
the 4 segments battery icon in the top right corner of the LCD display. When the battery
power level is very low, the "empty" icon will start flashing. Under this condition, the
battery should be recharged as soon as possible to continue normal operation of the
Perfectpro Rockpro.
Charging time from empty to full battery is approximately 6-7 hours (at room
temperature with the radio in Standby mode). The Perfectpro Rockpro can be charged in
Standby mode as well as in On mode while playing music. While playing music the
charging time will be longer than in Standby mode. When charging is in process the
battery icon segments will animate.
The Perfectpro Rockpro, for additional safety, will not start the charging process
when the battery is already full or nearly full.
GB
6