Mounting Cooker Hoods Without A Visor; Cooker Hood With Remote Motor Unit - Pelgrim ISW 700 Notice D'utilisation

A
P
Fig. 7. Extraction
Connect the cooker hood outlet flange (P) to
the duct (A). Put the plug in the wall socket.
Mounting the cover
Fig. 8. Cover
If the cupboard is deeper than the cooker
hood, you can mount the cover via the slotted
holes on the back of the hood. The depth can
be adjusted from 35 to 85 mm.
Mounting cooker hoods without a
visor
To be built-in with canopies (island models).
Saw out a hole in the bottom of the canopy,
with the dimensions 460x260 mm (see drawing
on the cover of the manual). The cooker hood
can be mounted with the 4 screws provided.
Mount a wall socket in the canopy recess for
the electrical connection.
Cooker hood with remote motor
unit
This cooker hood can only be used in
combination with a mechanical ventilation
system.
Control methods
There are two control methods:
The extraction is regulated with a switch
on the motor unit.
The motor unit is regulated with a switch
on the cooker hood.
The motor unit
The motor unit must be single phase (230 V-
50Hz) with various speeds. Whichever method
of extraction is selected, it must never be
possible to switch the motor unit off (see for
this only the motor unit manual). The various
possibilities are often given in terms of:
Medium or day setting, high or cooking
setting.
Note
The cooker hood with remote motor unit has a
mechanical cut-off valve in the duct. The
valve can be opened or closed with the handle
near the light panel.